Memorias de investigación
Artículos en revistas:
On Cup Anemometer Rotor Aerodynamics
Año:2012
Áreas de investigación
  • Ingeniería mecánica, aeronaútica y naval
Datos
Descripción
The influence of anemometer rotor shape parameters, such as the cups? front area or their center rotation radius on the anemometer?s performance was analyzed. This analysis was based on calibrations performed on two different anemometers (one based on magnet system output signal, and the other one based on an opto-electronic system output signal), tested with 21 different rotors. The results were compared to the ones resulting from classical analytical models. The results clearly showed a linear dependency of both calibration constants, the slope and the offset, on the cups? center rotation radius, the influence of the front area of the cups also being observed. The analytical model of Kondo et al. was proved to be accurate if it is based on precise data related to the aerodynamic behavior of a rotor?s cup.
Internacional
Si
JCR del ISI
Si
Título de la revista
Sensors
ISSN
1424-8220
Factor de impacto JCR
1,739
Información de impacto
Volumen
12
DOI
10.3390/S120506198
Número de revista
5
Desde la página
6198
Hasta la página
6217
Mes
MAYO
Ranking
Esta actividad pertenece a memorias de investigación
Participantes
Grupos de investigación, Departamentos, Centros e Institutos de I+D+i relacionados
  • Creador: Grupo de Investigación: Desarrollo y Ensayos Aeroespaciales
  • Centro o Instituto I+D+i: Instituto Universitario de Microgravedad "Ignacio da Riva"
  • Departamento: Infraestructura, Sistemas Aeroespaciales y Aeropuertos
  • Departamento: Vehículos Aeroespaciales