Observatorio de I+D+i UPM

Memorias de investigación
Communications at congresses:
A CASE STUDY: FINAL EXAM VERSUS CONTINUOUS ASSESSMENT MARKS FOR ELECTRICAL AND ELECTRONIC ENGINEERING STUDENTS
Year:2008
Research Areas
  • Processing and signal analysis
Information
Abstract
Comparación sobre examen final y evaluación continua en la enseñanza de ingeniería electrica. In this work we analyze the final marks obtained by the students of the course ¿Signals and Systems¿ of the Electrical and Electronic Engineering degree at the E.U.I.T. de Telecomunicación in the Universidad Politécnica de Madrid. Students within this course are assessed by two different methods: the first one consists of only a final exam while the second one implies students following a continuous and formative assessment method in which they are required to solve some open exercises almost every week and to fulfil a self-evaluation test every two weeks all along the whole semester. During the academic year 07/08, all the students of the course were assessed by both methods. Herein, we analyze the final marks (in a 0-10 scale) obtained by the students and compare the pass and fail rates obtained with both assessment methods when the minimum mark for passing is set to 5. This work was done with a sample of 210 students that were divided in 7 different groups with different lecturers. We have found that more than 70 % of the students where classified in the same group, either pass or fail, with both assessment methods. As for the rest, 15 % of the students failed with the continuous assessment method but succeeded in the final exam and the remaining 15% passed in the continuous assessment and failed in the finals. For these two groups, observations indicate that the first one corresponds to students that either deliberately chose to be evaluated only with a final exam, thus not presenting the required coursework, or presented medium quality works (marks around 4) and did a greater effort for preparing the exam. As for the last group, it should be highlighted that their effort during the course allowed the majority of them to obtain marks above 3.5 points in the final exam. Based on these results, we made simulations so as to have an insight in what would be the student¿s final marks when both assessment methods were combined with different weightings. Nowadays, this kind of combination is a common practice in many Universities, but usually the final exam has a higher weight (60 to 80 %) in the final student¿s marks. We found that even if the final exam¿s weight was only 25% and the continuous assessment¿s weight was 75%, only 3% of the students that had final exam marks lower than 3.5 would obtain a weighted mark over 5.0. Consequently, we conclude that continuous assessment gives practically the same pass/fail rates as the final exam.
International
Si
Congress
International Conference on Education, Research and Innovation, ICERI 2008
960
Place
Madrid, España
Reviewers
Si
ISBN/ISSN
978-84-612-5091-2
Start Date
17/11/2008
End Date
19/11/2008
From page
1
To page
4
Proceedings of the International Conference on Education, Research and Innovation, ICERI 2008
Participants
  • Autor: Cesar Benavente Peces (UPM)
  • Autor: Luis Arriero Encinas (UPM)
Research Group, Departaments and Institutes related
  • Creador: Grupo de Investigación: Grupo de Ingeniería de Radio (GIRA)
  • Departamento: Ingeniería de Circuitos y Sistemas
S2i 2019 Observatorio de investigación @ UPM con la colaboración del Consejo Social UPM
Cofinanciación del MINECO en el marco del Programa INNCIDE 2011 (OTR-2011-0236)
Cofinanciación del MINECO en el marco del Programa INNPACTO (IPT-020000-2010-22)