Descripción
|
|
---|---|
Software Product Line Engineering is becoming widely used due to the improvement it means when developing software products of the same family. The commonalities and variabilities of Software Product Lines (SPL) are identified during the Domain Engineering process and then, they are realized in the software architecture. Therefore, mechanisms to explicitly specify the commonalities and variabilities of SPLs at the architectural level are required. Most of the current mechanisms specify variations on the architecture by adding or removing architectural elements. However, it is also necessary to specify variations inside components. In this paper, we propose the notion of Plastic Partial Components to support internal variations. The specification of these components is performed using Invasive Software Composition techniques and without tangling the core and product architectures of the SPL. This contribution is illustrated through a SPL for developing domainspecific validation environments. | |
Internacional
|
No |
Nombre congreso
|
Software Architecture, 2009 & European Conference on Software Architecture. WICSA/ECSA 2009. Joint Working IEEE/IFIP Conference on |
Tipo de participación
|
960 |
Lugar del congreso
|
Cambridge |
Revisores
|
Si |
ISBN o ISSN
|
978-1-4244-4984-2 |
DOI
|
10.1109/WICSA.2009.5290808 |
Fecha inicio congreso
|
14/09/2009 |
Fecha fin congreso
|
17/09/2009 |
Desde la página
|
221 |
Hasta la página
|
230 |
Título de las actas
|
Software Architecture, 2009 & European Conference on Software Architecture. WICSA/ECSA 2009. Joint Working IEEE/IFIP Conference on |