|
Descripción
|
|
|---|---|
| On-line partial discharge (PD) measurements have become a common technique for assessing the insulation condition of installed high voltage (HV) insulated cables. When on-line tests are performed in noisy environments, or when more than one source of pulse-shaped signals are present in a cable system, it is difficult to perform accurate diagnoses. In these cases, an adequate selection of the non-conventional measuring technique and the implementation of effective signal processing tools are essential for a correct evaluation of the insulation degradation. Once a specific noise rejection filter is applied, many signals can be identified as potential PD pulses, therefore, a classification tool to discriminate the PD sources involved is required. This paper proposes an efficient method for the classification of PD signals and pulse-type noise interferences measured in power cables with HFCT sensors. By using a signal feature generation algorithm, representative parameters associated to the waveform of each pulse acquired are calculated so that they can be separated in different clusters. The efficiency of the clustering technique proposed is demonstrated through an example with three different PD sources and several pulse-shaped interferences measured simultaneously in a cable system with a high frequency current transformer (HFCT). | |
|
Internacional
|
Si |
|
JCR del ISI
|
No |
|
Título de la revista
|
IEEE Transactions on Dielectrics and Electrical Insulation |
|
ISSN
|
1070-9878 |
|
Factor de impacto JCR
|
|
|
Información de impacto
|
|
|
Volumen
|
|
|
DOI
|
|
|
Número de revista
|
|
|
Desde la página
|
469 |
|
Hasta la página
|
481 |
|
Mes
|
SIN MES |
|
Ranking
|
|