Observatorio de I+D+i UPM

Memorias de investigación
Artículos en revistas:
Design and Implementation of a Stereo Vision System on an Innovative 6DOF Single-Edge Machining Device for Tool Tip Localization and Path Correction
Año:2018
Áreas de investigación
  • Ingenieria mecanica
Datos
Descripción
In the current meso cutting technology industry, the demand for more advanced, accurate and cheaper devices capable of creating a wide range surfaces and geometries is rising. To fulfill this demand, an alternative single point cutting device with 6 degrees of freedom (6DOF) was developed. Its main advantage compared to milling has been the need for simpler cutting tools that require an easier development. To obtain accurate and precise geometries, the tool tip must be monitored to compensate its position and make the proper corrections on the computer numerical control (CNC). For this, a stereo vision system was carried out as a different approach to the modern available technologies in the industry. In this paper, the artificial intelligence technologies required for implementing such vision system are explored and discussed. The vision system was compared with commercial measurement software Dino Capture, and a dedicated metrological microscope system TESA V-200GL. Experimental analysis were carried out and results were measured in terms of accuracy.
Internacional
Si
JCR del ISI
Si
Título de la revista
Sensors
ISSN
1424-8220
Factor de impacto JCR
2,475
Información de impacto
Datos JCR del año 2017
Volumen
18
DOI
10.1007/978-3-31967180-2_21
Número de revista
9
Desde la página
1
Hasta la página
20 (Q2)
Mes
SEPTIEMBRE
Ranking
Q1 (mitad inferior) Datos JCR del año 2016 Q2 (mitad superior) Datos JCR del año 2017
Esta actividad pertenece a memorias de investigación
Participantes
  • Autor: Luis Alberto López Estrada (UPM)
  • Autor: Marcelo Fajardo Pruna (UPM)
  • Autor: Lidia Sánchez-González (Universidad de León, León, España)
  • Autor: Hilde Pérez (Universidad de León, León, España)
  • Autor: Laura Fernández-Robles (Universidad de León, León, España)
  • Autor: Antonio Vizan Idoipe (UPM)
Grupos de investigación, Departamentos, Centros e Institutos de I+D+i relacionados
  • Creador: Departamento: Ingeniería Mecánica
S2i 2021 Observatorio de investigación @ UPM con la colaboración del Consejo Social UPM
Cofinanciación del MINECO en el marco del Programa INNCIDE 2011 (OTR-2011-0236)
Cofinanciación del MINECO en el marco del Programa INNPACTO (IPT-020000-2010-22)