Abstract
|
|
---|---|
In a previous paper a new referenceless measurement set-up based on a reference antenna was used for characterizing the radiation of antennas in the planar scanner [1]. The method is based on using a low-cost receiver to retrieve the amplitude and phase of the signal. This paper explores the limitations of the method for different geometries and implements a multiprobe electromagnetic compatibility measurement system. Once the amplitude and phase are recovered, diagnostic techniques can be applied and also near-field to near or far-field transformations to calculate the field at distances defined by standards. The results demonstrate the good accuracy of the method in comparison with traditional electromagnetic compatibility laboratories. | |
International
|
Si |
Congress
|
41st Annual Meeting and Symposium of the Antenna Measurement Techniques Association |
|
960 |
Place
|
San Diego, California |
Reviewers
|
Si |
ISBN/ISSN
|
978-1-7281-4525-9 |
|
10.23919/AMTAP.2019.8906444 |
Start Date
|
06/10/2019 |
End Date
|
11/10/2019 |
From page
|
1 |
To page
|
6 |
|
Proceedings of the 41st Annual Meeting and Symposium of the Antenna Measurement Techniques Association |