Artículos en revistas:
Adsorbent materials from paper industry waste materials and their use in Cu(II) removal from water
Adsorbent materials from paper industry waste materials and their use in Cu(II) removal from water
Año:2009
Áreas de investigación
-
Química, -
Agricultura
Datos
|
Descripción
|
|
|---|---|
| This paper deals with the removal of Cu2+ from water using adsorbent materials prepared from paper industry waste materials (one de-inking paper sludge and other sludge from virgin pulp mill). Experimental results showed that de-inking paper sludge leads to mesoporous materials (Vmic/VT = 0.13 and 0.14), whereas the sludge from virgin pulp mill produces high microporous adsorbents (Vmic/VT = 0.39 and 0.41). Adsorbent materials were then used for Cu2+ removal from water at acid pH. During water treatment, heavy metals lixiviation from adsorbent materials was not produced. However, important Ca and Mg leaching was observed. Final pH significantly increases after treatment of water with adsorbent materials probably due to their elevated CaCO3 content. In general, highest Cu2+ removal was obtained using adsorbent materials from de-inking paper sludge. This result could be due to their higher content in oxygenated surface groups, high average pore diameter, elevated superficial charge density, high CaCO3 amount and high Ca and Mg exchange content. | |
|
Internacional
|
Si |
|
JCR del ISI
|
Si |
|
Título de la revista
|
JOURNAL OF HAZARDOUS MATERIALS |
|
ISSN
|
0304-3894 |
|
Factor de impacto JCR
|
2,975 |
|
Información de impacto
|
|
|
Volumen
|
165 |
|
DOI
|
|
|
Número de revista
|
0 |
|
Desde la página
|
736 |
|
Hasta la página
|
743 |
|
Mes
|
ENERO |
|
Ranking
|
|
Participantes
- Autor: Ana Maria Mendez Lazaro (UPM)
- Autor: Jose Manuel Fidalgo Alonso (UPM)
- Autor: Gabriel Gasco Guerrero (UPM)
- Autor: Sandra Paulina Barriga Curillo (UPM)
Grupos de investigación, Departamentos, Centros e Institutos de I+D+i relacionados
- Creador: Grupo de Investigación: Valorización de Recursos
- Departamento: Edafología
- Departamento: Ingeniería de Materiales
S2i 2023 Observatorio de investigación @ UPM con la colaboración del Consejo Social UPM
Cofinanciación del MINECO en el marco del Programa INNPACTO (IPT-020000-2010-22)