Memorias de investigación
Capítulo de libro:
Optimization of laser processes in n+ emitter formation for c-Si solar cells
Año:2009

Áreas de investigación
  • Materiales de construccion

Datos
Descripción
Punctual phosphorus diffused emitters were achieved by laser patterning phosphorus doped a-SiCx:H films deposited by PECVD as a doping source. Two different lasers at wavelengths of 1064 nm and 532 nm were used. Phosphorus diffusion was confirmed by Secondary Ion Mass Spectroscopy. We explored the effect of pulse energy and number of pulses per diffused point. The results show that a fine tune of the energy pulse is critical while the number of pulses has minor effects. Scanning Electron Microscopy (SEM) pictures and optical profilometry showed a laser affected area where the c-Si is melted, ejected and solidified quickly again. Typically, the diameter of the affected area for 1064 nm laser is between two and four times greater than for 532 nm laser. Optimum parameters for both lasers were determined to obtain best J-V curves nearly to ideal diode behavior. Comparing best J-V results, lower emitter saturation current density (Jo) and contact resistance are obtained with 532 nm laser. The improvement in Jo can be related mainly to the smaller affected areas observed by SEM while lower contact resistance can be attributed to that 532 nm laser has a more superficial action resulting in higher phosphorus concentration at the surface. The expected open voltage circuit for finished solar cells using these emitters is in the range of 640 mV for 532 nm laser and 620 mV for 1064 nm one. ¿
Internacional
Si
DOI
Edición del Libro
0
Editorial del Libro
Copyright 2009 WIP-Renewable Energies
ISBN
3-936338-25-6
Serie
Título del Libro
Proceedings of the International Conference 24th European Photovoltaic Solar Energy Conference and Exhibition
Desde página
1798
Hasta página
1802

Esta actividad pertenece a memorias de investigación

Participantes
  • Autor: A. Orpella Departamento de Ingeniería Electrónica, Universidad Politécnica de Cataluña
  • Autor: S. Blanque Departamento de Ingeniería Electrónica, Universidad Politécnica de Cataluña
  • Autor: C. Voz Departamento de Ingeniería Electrónica, Universidad Politécnica de Cataluña
  • Autor: Maria Isabel Sanchez Aniorte UPM
  • Autor: C. Blanque Departamento de Ingeniería Electrónica, Universidad Politécnica de Cataluña
  • Autor: Mónica Colina Brito UPM
  • Autor: I. Martín Departamento de Ingeniería Electrónica, Universidad Politécnica de Cataluña
  • Autor: Carlos Luis Molpeceres Alvarez UPM

Grupos de investigación, Departamentos, Centros e Institutos de I+D+i relacionados
  • Creador: Grupo de Investigación: Ingeniería y Aplicaciones del Láser
  • Centro o Instituto I+D+i: Centro Laser
  • Departamento: Física Aplicada a la Ingeniería Industrial
  • Departamento: Automática, Ingeniería Electrónica e Informática Industrial