Memorias de investigación
Ponencias en congresos:
INFLUENCE OF INITIAL POWER STABILIZATION OVER PV MODULES MAXIMUM POWER
Año:2009

Áreas de investigación
  • Agricultura

Datos
Descripción
Measurements that suppliers offer in flash lists, unfortunately do not always fit the actual power measured in independent laboratories like CIEMAT. In fact, independent measurements usually appear lower than those printed in the label and sometimes a value beyond the allowed tolerance pointed by the manufacturer in the same label. In addition, a valuable power reduction has been reported when Standard IEC - EN 50380 is applied (according to this, PV module must be exposed to sunlight more than 20kWh/m2 previously to performing the measurement), crystalline PV modules usually decrease its power around 1%, but descends greater than 4 % have also been reported. These power losses are only detected after the mentioned power stabilization
Internacional
Si
Nombre congreso
24th European Photovoltaic Solar Energy Conference and Exhibition
Tipo de participación
960
Lugar del congreso
Hamburgo
Revisores
Si
ISBN o ISSN
0000000000
DOI
Fecha inicio congreso
21/09/2009
Fecha fin congreso
25/09/2009
Desde la página
3464
Hasta la página
3468
Título de las actas
Libro de abstracts

Esta actividad pertenece a memorias de investigación

Participantes

Grupos de investigación, Departamentos, Centros e Institutos de I+D+i relacionados
  • Creador: Grupo de Investigación: Energía y Agricultura
  • Departamento: Ingeniería Rural