Observatorio de I+D+i UPM

Descripción
Rapid prototyping technologies (RP) enable solid models to be obtained from designs generated using CAD applications. Their increasing popularity in industry is due to the reductions in cost and time associated with the use of these models when verifying product development stages and improvements in end quality. However, these technologies can also be applied to enhance students¿ active learning in the teaching of multiple subjects connected with product development. Students can bring their designs to fruition and check any decisions taken in an economically acceptable way. This work shows how RP technologies can be exploited for teaching, using the full development of a gear pump. The work has been carried out with educational aims in the ¿Product Development Laboratory¿ of Madrid Polytechnic University (U.P.M.), for the subject ¿Design and Manufacturing with Polymers¿.
Internacional	Si
JCR del ISI	Si
Título de la revista	INT J ENG EDUC
ISSN	0949149X
Factor de impacto JCR	0,356
Información de impacto
Volumen	23
DOI
Número de revista	2
Desde la página	411
Hasta la página	418
Mes	ABRIL
Ranking

Esta actividad pertenece a memorias de investigación

• Autor: Andres Diaz Lantada (UPM)
• Autor: Javier Echavarri Otero (UPM)
• Autor: Jose Luis Muñoz Sanz (UPM)
• Autor: Hector Lorenzo Yustos (UPM)
• Autor: Pilar Lafont Morgado (UPM)
• Autor: Juan Manuel Muñoz Guijosa (UPM)

• Creador: Grupo de Investigación: GI-IM: Grupo de Investigación en Ingeniería de Máquinas
• Departamento: Ingeniería Mecánica y de Fabricación