Observatorio de I+D+i UPM

Memorias de investigación
Communications at congresses:
Analysis of the stress state of a halved and tabled traditional timber scarf joint with the finite element method
Year:2012
Research Areas
  • Civil engineering and architecture
Information
Abstract
The purpose of this study is to determine the stress distribution in the carpentry joint of halved and tabled scarf joint with the finite element method (FEM) and its comparison with the values obtained using the theory of Strength of Materials. The stress concentration areas where analyzed and the influence of mesh refinement was studied on the results in order to determine the mesh size that provides the stress values more consistent with the theory. In areas where stress concentration is lower, different mesh sizes show similar stress values. In areas where stress concentration occurs, the same values increase considerably with the refinement of the mesh. The results show a central symmetry of the isobar lines distribution where the centre of symmetry corresponds to the geometric centre of the joint. Comparison of normal stress levels obtained by the FEM and the classical theory shows small differences, except at points of stress concentration
International
Si
Congress
12th World Conference on Timber Engineering
960
Place
Auckland, Nueva Zelanda
Reviewers
Si
ISBN/ISSN
Start Date
16/07/2012
End Date
19/07/2012
From page
1
To page
5
Proceedings of abstracts
Participants
  • Autor: José Ramón Aira
  • Autor: Francisco Arriaga Martitegui (UPM)
  • Autor: Guillermo Iñiguez Gonzalez (UPM)
  • Autor: Manuel Guaita Fernández (UPM)
  • Autor: Miguel Esteban Herrero (UPM)
Research Group, Departaments and Institutes related
  • Creador: Grupo de Investigación: Construcción con Madera
  • Departamento: Construcción y Vías Rurales
S2i 2019 Observatorio de investigación @ UPM con la colaboración del Consejo Social UPM
Cofinanciación del MINECO en el marco del Programa INNCIDE 2011 (OTR-2011-0236)
Cofinanciación del MINECO en el marco del Programa INNPACTO (IPT-020000-2010-22)