Inspection/Analysis service for pieces under a microscope
Analysis, inspection and verification of pieces and tools under a 3D microscope.
R&D units, laboratories and start-ups associated with the UPM, along with private companies, are offered the chance to validate their research results with the production of physical prototype pieces or systems, including pre-series, according to the client¿s specifications and plans.
References from University Research Groups and R&D Centres:
- Fluid mechanics. HTSIE-UPM
- Material Resistance. HTSIE-UPM
- Metallurgy. HTSIE-UPM
- Machines and Mechanisms Laboratory. HTSIE-UPM
- Physics Department. HTS for Roads, Canals and Ports. UPM
- New Technologies Global System (NTGS)
- Inspiralia R&D
- Betia Ingeniería
- Mecanizados Pedrera
The service is offered by the Manufacturing Engineering (ME) Laboratory which belongs to the Community of Madrid Laboratories Network. The facilities are at the Higher Technical School for Industrial Engineers. C/ Jose Gutiérrez Abascal 2. 28006 Madrid.
Request for service
A request for service can be made by contacting the officer Dr. Juan Carlos Hernández via the e-mail . The applicant will be asked for technical and scientific information to enable assessment of the system to be made and the work needed identified, along with the technical and human resources needed to carry it out. The rates for other services are published on this web site and on the Universidad Politécnica de Madrid¿s web site under the heading ‘Prototype Production Services’ https://www.upm.es/Investigacion/estructuras/ServiciosCientificos .